The product assortment on this website may differ from what is available where you are located. Do you want to visit the American website instead?

NPA40X02

Straight Connectors, Reducers and End Caps

transparent, tension-proof, pressure-tight

  • transparent base body for visual control of the connection
  • tool-free assembly and disassembly possible
  • suitable for direct burial
  • unintentional opening is prevented by safety clip
  • transparent base body for visual control of the connection
  • tool-free assembly and disassembly possible
  • suitable for direct burial
  • unintentional opening is prevented by safety clip
Talk to an expert

The connectors, reducers and end caps allow a quick, easy and safe connection or gas/water sealing of microducts. The fitting program is available for three different applications:

  • Connectors for connecting microducts with identical duct diameters.
  • reducers for connecting microducts with different duct diameters
  • End caps for tension-proof and pressure-tight sealing of pipe runs

The connectors, reducers and end caps are suitable for direct burial without further protective measures. To prevent accidental opening of the products, they are supplied with a pre-assembled safety clip. To release the fittings, first remove the safety clip and then press down the release ring. The transparent housing makes it possible to see at first glance whether the component is correctly installed. The products comply with all relevant standards and are corrosion-resistant. In-house application is also possible.

Material:

  • Housing: Polyamide
  • O-ring: NBR
  • release ring: POM
  • Press-in sleeve: CW614N
  • Circlip: POM
  • Claw: Stainless steel 1.4310

Technical Information

Product Color

Housing: Transparent
Safety clip: blue
Release ring: black
Conformance
  • Base body made of impact-resistant material (proven with spade test followed by pressure testing)
  • Transparent base body for visual inspection of the connection
  • Clamping teeth made of corrosion-free spring steel (tested according to EN 61386-24 respectively EN 61386-1)
  • Pre-installed securing clip prevents undesired detachment
  • Suitable for direct installation in a sand bed below ground and blow-in pressure up to 15 bar
  • Internal pressure test according to DIN 16874 (170 h / 80 °C / 4,0 MPa)
  • Tested according to EN 50411
  • Also suitable for in-house use, flame-retardant according to EN 61386-22 and halogen-free
  • Fulfilment of the specifications of large telecommunication companies like Deutsche Telekom and Vodafone
Technical Notes
  • Injection pressure up to 16 bar
  • Permanent seal at least 0.5 bar
  • Bursting pressure at least 40 bar
  • Pre-installed safety clip prevents unintentional loosening
Ordering Information Packing unit see article list below.